Search results

Someone has to explain this joke.

You sound surprised, shouldn't be...

Consider me suitably chastised, sometimes beer gets in the way of judgement. Cunningham's law in full effect.

https://letmegooglethat.com/?q=transducer+location The bottom of the transducer should be even or just above the bottom of the hull. Positioned so that it is always in the water fully even when on plane.

Condolences

For those asking i have something similar to this: https://trollmasters.com/wired/trollmaster-pro/

If you go this route, I would strongly suggest Grimsby Tackle, he does extremely good work.

9.9 with a servo motor throttle control is what I have. I can troll no problem, only have to get up to start it, pull start, put it in gear. I control the speed with a dial on the dash board. Steering is tied to the main motor. If necessary, I can make it back to port at 6 - 7 MPH on the...

The egg goes on the fried rice. Oh, wait that's bami

It just sold today, sorry

Selling a 1999 18.5' Stratos Fish and Ski for a Senior Citizen friend. I do not know the boat's history other than a run up and down the Grand last fall. It ran out quite nice at that time and was able to handle moderate water on Erie. It comes with a 1998 135 HP Optimax, a kicker mount, full...

Launch off the south shore of Ontario and troll the mud line for browns. Shallow small stick baits with planer boards.

I have a Xi5 and had the same issue, it was a loose bolt.

She does now...

Check the other side.

Small stick baits. On your way out stop in at Grimsby Tackle for advice.

I like it! Only concern I would have is that the fasteners can be bacteria holders. Dishwasher safe?

You could try Redline Marine https://redlinemarine.net/ or https://www.marineonepowersports.com/motors-parts in Ancaster.

Try Chris Vandenberg Upholstery 905 730 0361 tell 'em Albert sent ya.

Good on you to find time to cook with a wee one in the house. Looks delish!